https://github.com/alvaroferran/BNO055

BNO055 Absolute orientation sensor board and library
https://github.com/alvaroferran/BNO055

Last synced: about 17 hours ago
JSON representation

BNO055 Absolute orientation sensor board and library

• Host: GitHub
• URL: https://github.com/alvaroferran/BNO055
• Owner: alvaroferran
• Created: 2015-09-14T13:47:27.000Z (almost 9 years ago)
• Default Branch: master
• Last Pushed: 2017-12-19T15:02:46.000Z (over 6 years ago)
• Last Synced: 2024-03-05T22:32:00.156Z (4 months ago)
• Language: C++
• Size: 430 KB
• Stars: 25
• Watchers: 10
• Forks: 8
• Open Issues: 2
• Metadata Files:
  • Readme: README.md

Lists

• awesome-stars - BNO055

README

        
# BNO055

#### 9DOF Absolute orientation sensor

 

![board](Board/3D/BNO055.jpg)

This repository contains the sensor board and a library for arduino. Both the board and the library are still under development and susceptible of improvement :)

#### BOARD

·The sensor works at 3.3V and can be used through UART or I2C by soldering the PS0 and PS1 pads below, as per the table below:

| PS1        | PS0           | Functionality  |

| ------------- |:-------------:| -----:|

| 0 | 0 | Standard/Fast I2C Interface|

| 0 | 1 |   HID over I2C |

| 1 | 0 |    UART Interface |

| 1 | 1 |    Reserved |

In order to be used with a 5V level microcontroller a 5V-3.3V level shifter must be used.

 

·It has two possible, hardware-defined I2C addresses, which are selectable through a solder pad, as in the following table:

| ID PAD       | I2C Address           | ID  |

| ------------- |:-------------:| -----:|

| Not soldered | 0x28 | A |

| Soldered | 0x29 | B  |

 

·The "I2C" pad enables the sensor's 4.7k pullup resistors. This pad should only be soldered if there were no other pullup resistors on the bus.

 

#### LIBRARY

· To install the library simply copy the folder "BNO055" into your folder "sketchbook/libraries/".

 

· In the "examples" subfolder a cheatsheet sketch is available which demonstrates how to read different data.