Ecosyste.ms: Awesome

An open API service indexing awesome lists of open source software.

https://github.com/FPGAwars/Alhambra-II-FPGA

:star2: Alhambra II FPGA board
https://github.com/FPGAwars/Alhambra-II-FPGA

alhambra-ii-fpga fpga fpga-board icestorm-toolchain opensource opensource-toolchain

Last synced: 3 months ago
JSON representation

:star2: Alhambra II FPGA board

Host: GitHub
URL: https://github.com/FPGAwars/Alhambra-II-FPGA
Owner: FPGAwars
License: lgpl-3.0
Created: 2018-04-20T10:02:23.000Z (about 6 years ago)
Default Branch: master
Last Pushed: 2023-10-22T10:56:05.000Z (8 months ago)
Last Synced: 2024-03-26T16:22:57.928Z (3 months ago)
Topics: alhambra-ii-fpga, fpga, fpga-board, icestorm-toolchain, opensource, opensource-toolchain
Homepage:
Size: 28.5 MB
Stars: 77
Watchers: 15
Forks: 27
Open Issues: 5
Metadata Files:
- Readme: README.md
- License: LICENSE

Lists

awesome-latticeFPGAs - Alhambra II

README

# Alhambra II FPGA board
Open FPGA for makers

![](https://github.com/FPGAwars/Alhambra-II-FPGA/raw/master/wiki/V1.0/Alhambra-II-01.jpg)

## Features

* iCE40HX4K (Lattice) FPGA development board (8K using opensource toolchain)
* Open hardware
* Compatible with the opensource [icestorm toolchain](Compatible with the opensource icestorm toolchain) and [Icestudio](https://github.com/FPGAwars/icestudio)
* Arduino like board: similar pinout than Arduino one
* You can Reuse most of available shields
* Control your robots / printbots from an FPGA
* FTDI 2232H USB device allows FPGA programming and UART interface to a PC
* ON/OFF electronic switch (turn off your mobile robot easily, switching on does not overload your USB port)
* 8 general purpose LEDs (user LEDs)
* 2 general purpose pushbuttons
* 32Mb flash memory for up to 30 bitstreams or user data
* 20 Input/output 3.3V (5V tolerant) pins
* All I/O pins include 200 ohms serial resistors for direct LED activation
* 4-Channels, 12 bits A/D converter
* Cold boot pins accessible from GPIO
* Switching regulators for high frequency processing at low power input
* 12 MHZ MEMS oscillator
* Reset pushbutton
* USB power supply, two connectors (up to 4.8A)
* Power pins and I/O pins allow permanent shortcircuit

## Documentation

[The proyect documentation is located in the wiki](https://github.com/FPGAwars/Alhambra-II-FPGA/wiki)

## Author

* [Eladio Delgado Mingorance](https://twitter.com/EladioDM)

## Credits

* Alhambra II V1.0 Board was derived from the [Icezum Alhambra V1.1 board](https://github.com/FPGAwars/icezum)

## License

![](https://github.com/FPGAwars/icezum/raw/master/wiki/attribution-share-alike-creative-commons-license.png)

Licensed under [Creative Commons Attribution-ShareAlike 4.0 International License](http://creativecommons.org/licenses/by-sa/4.0/)