https://github.com/oresat/oresat-endcaps

OreSat's +/-Z end caps, the PCBs on the very ends of the satellite.
https://github.com/oresat/oresat-endcaps

Last synced: about 1 month ago
JSON representation

OreSat's +/-Z end caps, the PCBs on the very ends of the satellite.

• Host: GitHub
• URL: https://github.com/oresat/oresat-endcaps
• Owner: oresat
• Created: 2018-12-03T05:52:38.000Z (about 6 years ago)
• Default Branch: master
• Last Pushed: 2024-04-08T14:31:39.000Z (9 months ago)
• Last Synced: 2024-04-08T18:02:36.068Z (9 months ago)
• Size: 12 MB
• Stars: 5
• Watchers: 9
• Forks: 2
• Open Issues: 0
• Metadata Files:
  • Readme: README.md

Awesome Lists containing this project

README

        
# "End Cap" PCBs for OreSat

These are the "end cap" PCBs that attach to the +Z and -Z ends of the satellites. Mostly these are to protect the end cards from "space", as well as to hold the magnetometers (two per end cap) as far as away from ferrous stuff as possible. It's also a good place for backup antennas, specifically patch antennas (S band and L1).

## Features

- Cutouts for deployable antennas

- Double magnetometers.

- Single vertical 10mm tall 1.27 mm connector that plugs into the "end card" card.

    - On the End Cap:  Harwin M55-6001242R 12 pin female vertical connector 

    - On the End Card below: Harwin M55-7011242R 12 pin male vertical connector

- No available RF connectors.

![OreSat +Z End Cap Picture](https://github.com/oresat/oresat-endcaps/raw/master/oresat0-minusz-end-cap/oresat0-minusz-end-cap-bot.png)

## LICENSE

Copyright the Portland State Aerospace Society, 2022.

This source describes Open Hardware that is licensed under CERN-OHL-S v2, or any later version.

You may redistribute and modify this source and make products using it under the terms of the CERN-OHL-S v2 (https://ohwr.org/cern_ohl_s_v2.txt).

This source is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN-OHL-S v2 for applicable conditions.

Source location: 

As per CERN-OHL-S v2 section 4, should You produce hardware based on this source, You must where practicable maintain the Source Location visible on the external case of the Gizmo or other products you make using this source.